Redundant EPS 12V 800W Power Supply
 Emacs / Zippy MRG-5800V4V (P/N: B00MRG080V006)
 PS-R2-ZP-MRG-5800V4V

Down Load:

Dimension: (WxDxH)

  • 150 x 86 x 200 mm
  • 5.91 x 3.39 x 7.87 inch  
  • 5-29/32 x 3-3/8 x 7-7/8 inch

Connectors:

  • 1x 20+4-pin Main Connector
  • 1x       8-pin EPS 12V
  • 1x       8-pin P4 12V (4-pin + 4-pin)
  • 1x       8-pin PCI Express  (6-pin + 2-pin GND)
  • 1x       6-pin PCI Express
  • 6x     15-pin SATA Power
  • 5x       4-pin Peripheral / IDE Power
  • 1x       4-pin Floppy Power
  • 1x       2-pin 3.68mm Buzzer Reset
  • 1x       2-pin 2.54mm TTL Signal
  • 1x                Power LED

Features:

  • Temperature Range:
    Operating 0°C ~ 40°C
    Storage: -20°C ~ 80°C
  • Hold up Time: DC output 12V must be maintain 16ms in regulation limit at normal input voltage.
  • Efficiency: Typical >80% at 115V, 25%~100% Max Load
  • Power Good Signal: On Delay 100ms to 500ms, Off Delay 1ms
  • Over Power Protection: 100~160%
  • Over Voltage Protection:
    +5V -> 5.7~6.5V
    +3.3V -> 3.9~4.7V
    +12V -> 13.3~14.3V
  • Over Current Protection:
    +3.3V -> 35.2~51.2A
    +5V -> 35.2~51.2A
    +12V -> 71.5~104A
  • Short Circuit Protection: +12V, -12V, +5VSB
  • Active PFC (full range), Meet IEC-1000-3-2 Class D
  • 12V Max. Current : 32A
  • Temperature Range:
    Operating 0°C ~ 40°C
    Storage: -20°C ~ 80°C
  • EMI Noise Filter: FCC Class B, CISPR22 Class B
  • Faulty Alarm Methods: LED, Buzzer, TTL Signal
  • Safety: to meet UL, TUV IEC-60950, RFI/EMI Standards
  • Remote On/Off Control
  • Cooling: 2x 40mm DC Fans (Module)

Specification:

  • Output Wattage: 800W
  • Best Solution for: Server, Workstation, Storage System, IPC

  • Dimension: (WxDxH)
    150 x 86 x 200 mm
    5.    91 x 3.39 x 7.87 inch  
    5-29/32 x 3-3/8 x 7-7/8 inch

  • Voltage: 90~264 VAC Full Range
  • Frequency: 47 ~ 63 Hz
  • Input Current: 9.0A @115V, 5A @230VAC
  • Inrush Current: 35A @115V, 75A @230VAC
  • Output Characteristics:
    Output
    Voltage    		 Min. Output
    Current    		 Max. Output
    Current    		 Peak Output
    Current    		 Regulation
    Load    		 Regulation
    Line    		 Output Ripple &
    Noise Max. [P-P]
    +5V 1 32.00 --- ±5% ±1% 50mV
    +12V 1 65 --- ±5% ±1% 120mV
    -12V 0 0.8 --- ±5% ±1% 120mV
    3.3V 1.0 32 --- ±5% ±1% 50mV
    +5VSB 0.1 3.5 --- ±5% ±1% 50mV

    Remarks:
    > Total Current of +5V & + 3.3V not exceed 190A
    > Total Output Power NOT Exceed 800W

* The power supply is for chassis assembly only and is not allowed to be operated as stand-alone component. Final assembly has to comply with corresponding EMC and safety regulations.