ATX12V Switching Power Supply
FSP250-601U for 1U IPC Server/Workstation
SPI (Sparkle Power) FSP Group (Fortron Source)
 PS-1U-FSP250-601U

 Down Load FSP250-601U PDF Drawing

Features:
> Complied with ATX and ATX12V standard
> Active Power Factor Correction (PFC) meet EN61000-3-2
> High efficiency and reliability
> Remote ON/OFF function
> Internal 12V DC fan included
> Noise Killer (thermal fan speed control function)
> Low noise and ripple
> Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
> Output over voltage, short circuit, and over current protection
> 100% Hi-pot, ATE, and burn-in tested
> Re-settable power shut down
> Approved by UL60950-1, CSA C22.2 NO. 60950, TUV EN60950 or VDE EN60950, NEMKO EN60950 (CB Report)

 Specification:
> Temperature Range: Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +80°C
> Humidity: 5 ~ 95% on operating and storage
> Dielectric Withstand: Input to frame ground 1800 VAC for 1 second
> Efficiency: 68% at minimum measured at nominal AC main voltage and frequency with maximum load on all outputs
> Rise time: Less than 20ms
> Hold-up Time: 20ms minimum at nominal input voltage
> Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
> Leakage Current: Not exceed 3.5mA at 264Vac, 50Hz
> MTBF: 100,000 hours on maximum load at +25°C
> Dimensions (WxHxL): 205x100x40.5x205mm/.9x1.6x8in

 Input Characteristics:
> Input Range: 90 ~ 264Vac (RMS), Full Range Input
> Frequency: 47 ~ 63Hz
> Input Current: 5A (RMS) @115Vac, 2.5A (RMS) @230Vac
> Inrush Current: 50A Max @115Vac, 80A Max @230Vac cold start

Output Characteristics:
Output Voltage Minimum Load Maximum Load Peak Load Reg. Line Reg. Ripple Noise
+3.3V 0.3A 16.0A -- ± 5% ± 1% 50mV P-P
+5V 2.0A 25.0A -- ± 5% ± 1% 50mV P-P
+12V 0.2A 13.0A 16A ± 5% ± 1% 120mV P-P
-5V 0.0A 0.3A -- ± 5% ± 1% 100mV P-P
-12V 0.0A 0.8A -- ± 5% ± 2% 120mV P-P
+5Vsb 0.0A 2.0A -- ± 5% ± 1% 100mV P-P

* +5V and +3.3V total output not exceed 145W
* +3.3V, +5V, and +12V total output cannot exceed 230W
* This subject power supply is 250W