ATX Power Supply with TFX Form Factor
SPI300T8AB-B204 (9PA300CP10) by Sparkle Power
 PS-TFX-SPI300T8AB-B204

Link:

Dimension:

  • WxHxL: 85 x 65 x 175mm

  • WxHxL: 3.35 x 2.56 x 6.84 inch

  • WxHxL: 3-22/64 x 2-9/16 x 6-27/32 inch

Connectors:

  • 1x 20+4-pin Main Connector

  • 1x       4-pin (P4 2x2)

  • 3x     15-pin SATA Power

  • 3x       4-pin Peripheral / IDE Power

  • 1x       4-pin Floppy Power

Features:

  • Complied with TFX12V standard

  • Active Power Factor Correction (PFC) meet EN61000-3-2

  • High efficiency and reliability

  • Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).

  • Remote ON/OFF function

  • Internal 12V DC fan included

  • Noise Killer (thermal fan speed control function)

  • Low noise and ripple

  • Output over voltage, short circuit, and over current protection

  • 100% Hi-pot, ATE, and burn-in tested

  • Re-settable power shut down

  • Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation

  • Approved by CUL/UL60950-1, FIMKO EN60950-1, TUV

  • EN60950-1 (CB Report), CE

Specification:

  • Temperature Range: Operating: 0°C ~ +35°C ; storage & shipping: -40°C ~ +80°C

    •

  • Humidity: 5 ~ 85% on operating, 5 ~ 95% on storage

  • Dielectric Withstand: Primary frame ground 1800V AC for 1 second

  • Efficiency: 82% minimum

  • Rise time: Less than 20ms

  • Hold-up Time: 16ms minimum at nominal input voltage

  • Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)

  • Leakage Current: Less than 3.5mA .

  • MTBF: 100,000 hours on maximum load at +25°C

Input Characteristics

  • Input Range: 90 ~ 264Vac (RMS), Full Range Input

  • Frequency: 47 ~ 63Hz

  • Input Current: Max 4A (RMS) @ 115Vac,2A (RMS) @ 230Vac

  • Inrush Current: No damage

Output Characteristics:
Output Voltage Minimum Load Normal Load Maximum Load Load Reg. Ripple Noise
+3.3V 0.1A 10.5A 21A ± 5% 50mV P-P
+5V 0.2A 7.5A 15A ± 5% 50mV P-P
+12V 1 0.1A 5.5A 13A ± 5% 120mV P-P
+12V 2 0.5A 4.0A 13A ± 5% 120mV P-P
-12V 0.0A 0.15A 0.3A ± 10% 120mV P-P
+5Vsb 0.0A 1.0A 2.0 A ± 5% 50mV P-P

  • +3.3V and +5V total output not exceed 103W

  • +12V1 & +12V2 total output not exceed 264W