ATX Power Supply with TFX Form Factor
FSP180-60SAV-B by SPI Sparkle Power
PS-TFX-FSP180-60SAV

Down Load FSP180-60SAV PDF Drawing

Dimension:
> WxHxL: 86x65.5x174.9 mm (3.4"x2.5"x6.7")

Connectors:
> 1x 20-pin Main Connector
> 1x 4-pin (P4 2x2)
> 2x 4-pin Peripheral / IDE Power
> 1x 4-pin Floppy Power

Features:
> Complied with TFX12V standard
> High efficiency and reliability
> Remote On/Off function
> Internal 12V DC fan included
> Noise Killer (Thermal fan speed control function)
> Low noise and ripple
> Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
> Output over voltage, short circuit, and over current protection
> 100% Hi-pot, ATE, and burn-in tested
> Re-settable power shut down
> Approved by UL 1950, CSA C22.2 Level 3, TUV EN60950, NEMKO (CB Report)

Specification:
> Temperature Range: Operating 0° C ~ +50° C on full load; storage & shipping -20° C ~ +65° C
> Humidity: 90% on operating and 95% on storage
> Dielectric Withstand: Input to frame ground 1800V AC for 1 second
> Efficiency: 60% at minimum measured at nominal AC main voltage and frequency with maximum load on all output
> Rise Time: Less than 20ms on all output
> Hold-up Time:16.6ms minimum at nominal input voltage
> Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
> Leakage Current: Less than 3.5mA
> MTBF: 100,000 hours on maximum load at +25° C degree
> Dimension (WxHxL): 86x65.5x174.9mm/3.4"x2.5"x6.7" inches

Output Characteristics:

Output Voltage	Minimum Load	Maximum Load	Load Reg.	Line Reg.	Ripple Noise
+3.3V	0.5A	11.5/16.7A	± 5%	± 1%	50mV P-P
+5V	1.0A	16/12.6A	± 5%	± 1%	50mV P-P
+12V	2.0A	10A	± 5%	± 1%	120mV P-P
-5V	0.0A	0.2A	± 10%	± 2%	120mV P-P
-12V	0.0A	0.3A	± 10%	± 2%	120mV P-P
+5Vsb	0.0A	2.0 A	± 5%	± 1%	50mV P-P
*+5V and +3.3V total output not exceed 118W *+3.3V, +5V, and +12V total output cannot exceed 165W *When +3.3Vis load on 16.7A, the +5V maximum load is 12.6A *When +3.3Vis load on 11.5A, the +5V maximum load is 16A