• SPI300GLS-B204 9PA300A362 drawing

Dimension: (WxHxD)

• 125 x 63 x 100 mm
• 4.92 x 2.48 x 3.94 inch
• 4-29/32 x 2-15/32 x 3-15/16 inch

Connectors:

• 1x 20+4-pin Main Connector
• 1x       4-pin P4 (2x2)
• 2x     15-pin SATA Power
• 3x       4-pin Peripheral / IDE Power
• 1x       4-pin Floppy Power

Features:

• Complied with SFX12V standard
• Active Power Factor Correction (PFC) meet EN61000-3-2
• High efficiency and reliability
• Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).
• Remote ON/OFF function
• Internal 12V DC fan included
• Noise Killer (thermal fan speed control function)
• Low noise and ripple
• Output over voltage, short circuit, and over current protection
• 100% Hi-Pot, ATE, and burn-in tested
• Re-settable power shut down
• Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation Approvedy CUL/UL60950-1, CSA C22.2
• EN60950-NEMKO EN60950-1+CB report, FCC, EMC

Specifications:

• Temperature Range: Operating: 0°C ~ +50°C ; storage & shipping: -20°C ~ +80°C
• Humidity: 5 ~ 95% on operating, 5 ~ 95% on storage
• Dielectric Withstand: Primary frame ground 1800V AC for1 second
• Efficiency: 80% minimum, 84.3% on Typical Load .
• Rise time: Less than 20ms
• Hold-up Time: 17ms minimum at nominal input voltage
• Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
• Leakage Current: Less than 3.5mA .
• MTBF: 100,000 hours on maximum load at +25°C
• Dimensions (LxWxH): 100x125x63.5mm / 4x4.9x2.5 inch

Input Characteristics:

• Input Range: 90 ~ 265Vac, Full Range Input
• Frequency: 47 ~ 63Hz
• Input Current: Max 4A @ 115Vac, 2A @ 230Vac
• Inrush Current: No damage

Output Characteristics:

Output Voltage	Minimum Load	Normal Load	Maximum Load	Peak Load	Load Reg.	Ripple Noise
+3.3V	0.5A	10A	20A	---	± 5%	50mV P-P
+5V	0.3A	11A	22A	---	± 5%	50mV P-P
+12V1DC	1.0A	8A	16A	---	± 5%	120mV P-P
+12V2DC	1.0A	8A	16A	19A	± 5%	120mV P-P
-12V	0.0A	0.25A	0.5A	---	± 10%	120mV P-P
+5Vsb	0.0A	1.00A	2.0A	2.5A	± 5%	50mV P-P
Note: +3.3V and +5V total output not exceed 125W Total output for this subject power supply is 300W