E-Machine SFX12V 300W Power Supply
SFX 12V Micro ATX Switching Power Supply
FSP300-60GNV 9PA300C101
 PS-SFX-FSP300-60GNV

Down Load:

Dimension: (wxHxD)

  • 125 x 63.5 x 130 mm
  • 4.92 x 2.5 x5.12 inch
  • 4-29/32 x 2-1/2 x 5-1/8 inch

Connectors:

  • 1x 20+4-pin Main Connector
  • 1x       4-pin P4 (2x2)
  • 2x     15-pin SATA Power
  • 3x       4-pin Peripheral / IDE Power
  • 1x       4-pin Floppy Power

Features:

  • Complied with SFX and SFX12V standard

  • Active Power Factor Correction (PFC) meet EN61000-3-2

  • High efficiency and reliability

  • Remote ON/OFF function

  • Internal 12V DC fan included

  • Noise Killer (thermal fan speed control function)

  • Low noise and ripple

  • Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation

  • Output over voltage, short circuit, and over current protection

  • 100% Hi-pot, ATE, and burn-in tested

  • Re-settable power shut down

  • Approved by UL60950, CSA C22.2 NO. 60950, TUV EN60950 or VDE EN60950, NEMKO EN60950 (CB Report), CE

Specifications:

  • Temperature Range:Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +80°C

  • Humidity: 5 ~ 95% on operating and storage

  • Dielectric Withstand: Input to frame ground 1800 VAC for 1 second

  • Efficiency: 75%at minimum measured at nominal AC main voltage and frequency with full load on all outputs

  • Rise time: Less than 20ms

  • Hold-up Time: 17ms minimum at nominal input voltage

  • Power Good Signal:Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)

  • Leakage Current: Not exceed 3.5mA

  • MTBF: 100,000 hours on maximum load at +25°C

  • Dimensions (LxWxH): 130x125x63.5mm/5.1x5x2.5inch

Input Characteristics:

  • Input Range: 90 ~ 265Vac (RMS), Full Range Input

  • Frequency: 47 ~ 63Hz

  • Input Current: 4A (RMS) @115Vac, 2A (RMS) @230Vac

  • Inrush Current: No damage, typical 80A Max at cold start

Output Characteristics:

Output Voltage Minimum Load Normal Load Maximum Load Load Reg. Line Reg. Ripple Noise
+3.3V 0.5A --- 18A ± 5% ± 1% 50mV P-P
+5V 0.3A --- 18A ± 5% ± 1% 50mV P-P
+12V1DC 1.0A --- 8A ± 5% ± 1% 120mV P-P
+12V2DC 1.0A --- 16A ± 5% ± 1% 120mV P-P
-12V 0.0A --- 0.5A ± 10% ± 1% 120mV P-P
+5Vsb 0.0A --- 2.0A ± 5% ± 1% 50mV P-P

Note:
> +3.3V and +5V total output not exceed 125W
> +12V1DC & +12V2DC total current not exceed 22A
> Total output for this subject power supply is 300W