Down Load

• FSP350-50BR2 9PR3500200 Drawing

Dimension:
> Dimension: LxWxH 150x86x225mm (5.9”x3.4”x8.9”)

Connectors:
> 1x 20-pin Main Connector (L: 150 mm)
> 1x 8-pin (2x4) (L: 150 mm)
> 1x 4-pin (P4 2x2) (L: 150 mm)
> 2x 15-pin SATA Power (L: 200 + 75 mm)
> 3x 4-pin Peripheral / IDE Power
> 2x 4-pin Floppy Power

Features:
> Complied with ATX12V standard
> Hot swappable 1+1 redundant
> Active Power Factor Correction Meeting with EN61000-3-2
> High efficiency and reliability
> Remote On/Off function
> Internal 12V DC fan included on each module
> Low noise and ripple
> Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
> Output over voltage, short circuit, and over current protection
> 100% Hi-pot, ATE, and burn-in tested
> Re-settable power shut down
> LED Indicator, PS failure signal, and Fan failure signal
> +3.3V, +5V, and +12V Remote Sensing
> Approved by cUL/UL 60950, TUV EN60950, NEMKO EN60950 (CB Report), CE

Specification:
> Temperature Range: Operating +5° C ~ +40° C on full load; storage & shipping -10° C ~ +50° C
> Humidity: 90% on operating and 95% on storage
> Dielectric Withstand: Input to frame ground 1800V AC for 1 second
> Efficiency: 65% typical measured at 115V AC main voltage and frequency full load
> Rise Time: 50ms maximum
> Hold-up Time: 20ms minimum at nominal input voltage
> Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
> Leakage Current: Not exceed 3.5mA at nominal input
> MTBF: 100,000 hours on maximum load at +25° C degree
> Dimension (WxHxL): 150x86x225mm/5.9”x3.4”x8.9” inches

Input:
> Input Range: 90~264V AC, Full Range Input
> Frequency: 47~63Hz
> Input Current: 7A (RMS) @115V AC, 3.5A (RMS) @230V AC
> Inrush Current: Comply with EN 61000-3-3

Output Characteristics:

Output Voltage	Minimum Load	Maximum Load	Load Reg.	Line Reg.	Ripple Noise
+3.3V	0.3A	28.0A	± 5%	± 1%	50mV P-P
+5V	1.5A	30.0A	± 5%	± 1%	50mV P-P
+12V	1.0A	15.0A	± 5%	± 1%	120mV P-P
-12V	0.0A	0.8A	± 10%	± 1%	120mV P-P
+5Vsb	0.0A	2.0A	± 5%	± 1%	50mV P-P
*+5V and +3.3V total output shall not exceed 157W *+5V, +12V and +3.3V total output shall not exceed 330W * Total output power shall not exceed 350W