ATX Switching Power Supply
FSP500U4BB-B204 P/N: 9PA5004001
SPI (Sparkle Power) FSP Group (Fortron Source)
for 1U IPC Server/Workstation
 PS-1U-xxx

Links:

Dimension: (WxHxL)

  • 100 x 40.5 x 220 mm
  • 3.94 x 1.59 x 8.66 inch
  • 3-15/16 x 1-19/32 x 8-21/32 inch

Connectors:

  • 1x 20+4-pin to Mother Board
  • 1x       8-pin (4x2)
  • 1x       8-pin (2x2 + 2x2)
  • 4x     15-pin SATA Power
  • 4x       4-pin IDE Power
  • 1x       4-pin Floppy Power

Features:

  • Complied with ATX12V standard
  • Active Power Factor Correction (PFC) meet EN61000-3-2
  • High efficiency and reliability
  • Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).
  • Remote ON/OFF function
  • Internal 12V DC fan included
  • Low noise and ripple
  • Output over voltage, short circuit, and over current protection
  • 100% Hi-pot, ATE, and burn-in tested
  • Re-settable power shut down
  • Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
  • Approved by : UL/CUL60950-1 2nd TUV EN60950-1 2nd, CB 60950-1 2nd , FCC, EMC

Specification:

  • Temperature Range: Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +80°C
  • Humidity: 85% on operating, 95% on storage
  • Dielectric Withstand: Primary frame ground 1800V AC for 2 second
  • Efficiency: Typical > 85%
  • Rise time: Less than 20ms
  • Hold-up Time: 16 ms minimum at nominal input voltage
  • Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
  • Leakage Current: Less than 3.5mA at 264Vac, 63Hz
  • MTBF: 100,000 hours on maximum load at +25°C
  • Dimensions (LxWxH): 220x100x40.5mm /8.66x3.9x 1.6 inch

Input Characteristics:

  • Input Range: 90 ~ 264Vac, Full Range Input
  • Frequency: 47 ~ 63Hz
  • Input Current: Max 8A @ 115Vac, 4.0A @ 230Vac
  • Inrush Current: No Damage

Output Characteristics:

Output Voltage Minimum Load Normal Load Maximum Load Load Reg. Ripple Noise
+3.3V 0.5A 10.0A 20.0A ± 5% 50mV P-P
+5V 1.0A 10.0A 20.0A ± 5% 50mV P-P
+12V1 0.5A 8.0A 16.0A ± 5% 120mV P-P
+12V2 1.0A 8.0A 16.0A ± 5% 120mV P-P
+12V3 1.0A 8.0A 16.0A ± 5% 120mV P-P
-12V 0.0A 0.25A 0.5A ± 10% 120mV P-P
+5Vsb 0.0A 1.5A 3.0A ± 5% 50mV P-P

Note:

  • +3.3V & +5V total output shall not exceed 130W.

  •  +12V1 & +12V2 & +12V3 total output shall not exceed 39A.

  • Total output for this subject power supply is 500W