Down Load:

• SPI4002UC (P/N: 9PA4005101) Drawing

Dimension: (WxHxL)

• 100 x 70 x 240 mm
• 3.94 x 2.76 x 9.45 inch  
• 3-15/16 x 2-3/4 x 9-7/16 inch

Connectors:

• 1x 20+4-pin Main Connector
• 1x       8-pin EPS 12V
• 1x   4+4-pin P4 12V x2
• 2x     15-pin SATA Power Connector
• 4x       4-pin Peripheral / IDE Power
• 1x       4-pin Floppy Power

Features:

• Complied with ATX12V/ EPS12V standard

• Active Power Factor Correction (PFC) meet EN61000-3-2

• High efficiency and reliability

• Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).

• Remote ON/OFF function

• Internal 12V DC fan included

• Low noise and ripple

• Output over voltage, short circuit, and over current protection

• 100% Hi-pot, ATE, and burn-in tested

• Re-settablower shut down

• Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22ass B at 230Vac operation

• Approved : UL,CSA22.2 NO or CUL 60950-1, TUV or VDE, EMC,FCC ,CE, CB report.

Specification:

• Temperature Range:Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +80°C

• Humidity: 85% on operating, 95% on storage

• Dielectric Withstand:Primary frame ground 1800V AC for1 second

• Efficiency: Typical up to 85%

• Rise time: Less than 20ms

• Hold-up Time: 17 ms minimum at nominal input voltage

• Power Good Signal:Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)

• Leakage Current: Less than 3.5mA at 264Vac, 50Hz

• MTBF: 100,000 hours on maximum load at +25°C

• Dimensions (LxWxH): 240x100x70mm /9.4x3.9x 2.7 inch

• Input Range: 90 ~ 264Vac, Full Range Input

• Frequency: 47 ~ 63Hz

• Input Current: Max 6.3A @ 115Vac, 3.0A @ 230Vac

• Inrush Current: No Damage

Output Characteristics:

Output Voltage	Min. Load	Normal Load	Max. Load	Load Reg.	Ripple & Noise
3.3V	0.5A	10A	20A	±5%	50mV P-P
+5V	0.5A	10A	20A	±5%	50mV P-P
+12V1	1.5A	8A	16A	±5%	120mV P-P
+12V2	1.5A	8A	16A	±5%	120mV P-P
-12V	0A	0.25A	0.5A	±10%	120mV P-P
+5VSB	0A	1.25A	2.5A	±5%	50mV P-P
Remarks: > +3.3V and +5V total output not exceed 150W > Total output for this subject power supply is 400W

* The power supply is for chassis assembly only and is not allowed to be operated as stand-alone component. Final assembly has to comply with corresponding EMC and safety regulations.