EPS12V Switching Power Supply
FSP650-802U for 2U IPC Server/Workstation
SPI (Sparkle Power) FSP Group (Fortron Source)
 PS-2U-FSP650-802U

Links:

Connectors:

  • 1x 24-pin EPS 12V to Mother Board
  • 1x 8-pin (4x2)
  • 1x 4+4-pin (2x2, 2-set)
  • 3x 15-pin SATA Power
  • 5x 4-pin to IDE Power
  • 1x 4-pin to Floppy Power

Dimension: (WxHxL)

  • 106 x 82.2 x 300 mm
  • 4.17 x 3.24 x 11.81 inch
  • 4-5/32 x 3-1/4 x 11-13/16 inch

Features:

  • Complied with ATX, ATX12V and EPS12V standard

  • Active Power Factor Correction (PFC) meet EN61000-3-2

  • High efficiency and reliability

  • Remote ON/OFF function

  • Internal 12V DC fan included

  • Noise Killer (thermal fan speed control function)

  • Low noise and ripple

  • Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation

  • Output over voltage, short circuit, and over current protection

  • 100% Hi-pot, ATE, and burn-in tested

  • Re-settable power shut down

  • Approved by UL60950, CSA C22.2 NO. 60950, TUV EN60950 or VDE EN60950, NEMKO EN60950 (CB Report), CE

Specification:

  • Temperature Range: Operating: 0°C ~ +50°C on full load; storage & shipping: -20°C ~ +70°C

  • Humidity: 5 ~ 95% on operating and storage

  • Dielectric Withstand: Input to frame ground 1800 VAC for 1 second

  • Efficiency: 70% at minimum measured at nominal AC 115VAC with maximum load on all outputs

  • Rise time: Less than 70ms

  • Hold-up Time: 20ms minimum at nominal input voltage

  • Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)

  • Leakage Current: Not exceed 3.5mA at 264Vac, 50Hz

  • MTBF: 100,000 hours on maximum load at +25°C

  • Dimensions (LxWxH):300x106x82.2mm/11.8x4.2x3.2inch

Input Characteristics:

  • Input Range: 95 ~ 265Vac (RMS), Full Range Input

  • Frequency: 47 ~ 63Hz

  • Input Current: 8A (RMS) @115Vac, 4A (RMS) @230Vac

  • Inrush Current:50A Max @115Vac,50A Max @230Vac cold start

Output Characteristics:

Output Voltage Minimum Load Maximum Load Load Reg. Line Reg. Ripple Noise
+3.3V 0.5A 30.0A ± 5% ± 1% 50mV P-P
+5V 0.5A 30.0A ± 5% ± 1% 50mV P-P
+12V1 0.3A 12.5A ± 5% ± 1% 120mV P-P
+12V2 0.3A 12.5A ± 5% ± 1% 120mV P-P
+12V3 0.5A 14.0A ± 5% ± 1% 120mV P-P
+12V4 0.3A 8.0A ± 5% ± 1% 120mV P-P
-5V 0.0A 0.3A ± 10% ± 1% 100mV P-P
-12V 0.0A 0.8A + 9% / -5% ± 2% 120mV P-P
+5Vsb 0.0A 2.0A ± 5% ± 1% 50mV P-P

* +5V and +3.3V total output not exceed 220W
* +3.3V, +5V, and +12V total output cannot exceed 630W (+12V Outputs shall not exceed 45A)
* This subject power supply is 650W