AT Power Supply PS2 Type
FSP / SPI - SPI300G PN: 9PP3000115
 PS-AT-PS2-SPI300G

Links:

Connectors:

  • 1x I/O Power Switch
  • 1x P8/P9 Main Connector
  • 4x 4-pin Peripheral / IDE Power
  • 2x 4-pin Floppy Power

Dimension: (WxHxD)

  • 150 x 86 x 140 mm
  • 5.9 x 3.4 x 5.5 inch
  • 5-29/32 x 3-3/8 x 5-1/2 inch

Features:

  • Complied with AT standard

  • High efficiency and reliability

  • Internal 12V DC fan included

  • Low noise and ripple

  • Complies with FCC part 15 subpart J class B and CISPR 22 class B

  • Output over voltage, short circuit, and over current protection

  • 100% Hi-pot, ATE, and burn-in tested

  • Re-settable power shut down

  • Approved by UL60950-1, CSA C22.2 NO. 60950-1

Specifications:

  • Temperature Range: Operating: 0°C ~ +40°C on full load; storage & shipping: -20°C ~ +65°C

  • Humidity: 90% on operating and 95% storage

  • Dielectric Withstand: Input to frame ground 1800 VAC for 1 second

  • Efficiency: 65% at minimum measured at nominal AC main voltage and frequency with maximum load on all outputs

  • Rise time: Less than 100mS on all Outputs

  • Hold-up Time: 16.6ms minimum at nominal input voltage

  • Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)

  • MTBF: 50,000 hours on maximum load at +40°C

  • Dimensions (LxWxH): 140x150x86mm/5.5x5.9x3.4in

Input Characteristics

  • Input Range: 90 ~ 132/180~264Vac (RMS), Manual Select

  • Frequency: 47 ~ 63Hz

  • Input Current: 6A (RMS) @115Vac, 3A (RMS) @230Vac

  • Inrush Current: 55A Max @132Vac cold start

Output Characteristics:

Output Minimum Load Maximum Load Load Reg. Line Reg. Ripple & Noise
+5V 3A 30A +/- 5% +/- 1% 50mV P-P
+12V 1A 12A +/- 5% +/- 1% 120mV P-P
-5V 0A 0.5A +/- 10% +/- 2% 150mV P-P
-12V 0A 0.5A +/- 10% +/- 2% 150mV P-P

* This subject power supply is 300W