FLEX ATX Switching Power Supply
 SPI180LE 180W Flex ATX P/N: 9PA1803502
Active PFC & RoHS Compliant, 80%+ Efficiency
WxHxL: 3.2x1.6x6-inch (81.5x40.5x150mm)
 PS-FLX-SPI180LE
Down Load SPI180LE Drawing

Connectors:
> 1x 20+4-pin Main Connector
> 1x       4-pin P4 (2x2)
> 2x     15-pin SATA Power
> 3x       4-pin Peripheral / IDE Power
> 1x       4-pin Floppy Power

Features:
> Complied with Flex ATX and ATX12V standard
> Active Power Factor Correction (PFC) meet EN61000-3-2
> High efficiency and reliability
> Compatible with European Union Directive 2002/95/EC (Restriction on Hazardous Substances).
> Remote ON/OFF function
> Internal 12V DC fan included
> Low noise and ripple
> Output over voltage, short circuit, and over current protection
> 100% Hi-pot, ATE, and burn-in tested
> Re-settable power shut down
> Complies with FCC part 15 subpart J class B 115Vac operation, and CISPR 22 class B at 230Vac operation
> Approved by CUL/UL60950-1, TUV EN60950-1 , NEMKO EN60950-1 (CB Report) CE

Specification:
> Temperature Range: Operating: 0°C ~ +50°C; storage & shipping: -20°C ~ +80°C
> Humidity: 85% on operating, 95% on storage
> Dielectric Withstand: Primary frame ground 1800V AC for 1 second
> Efficiency: 68% at minimum measured at nominal AC main voltage and frequency with maximum load on all output
> Rise time: Less than 20ms
> Hold-up Time: 17ms minimum at nominal input voltage
> Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms minimum (TTL and CMOS compatible)
> Leakage Current: Less than 3.5mA at 264Vac, 50Hz
> MTBF: 100,000 hours on maximum load at +25°C
> Dimensions (LxWxH):150x81.5x40.5mm /6x3.2x1.6inch

Input Characteristics:
> Input Range: 90 ~ 265Vac (RMS), Full Range Input
> Frequency: 47 ~ 63Hz
> Input Current: Max 4A (RMS) @ 115Vac, 2A (RMS) @ 230Vac
> Inrush Current: No damage.

Output Characteristics:
Output Voltage Minimum Load Normal Load Maximum Load Load Reg. Line Reg. Ripple Noise
+3.3V 0.3A 7A 14A ± 5% ± 1% 50mV P-P
+5V 0.3A 8A 16A ± 5% ± 1% 50mV P-P
+12V 1.5A 7A 14A ± 5% ± 1% 120mV P-P
-12V 0.0A 0.25A 0.5A ± 10% ±1% 120mV P-P
+5Vsb 0.0A 1.00A 2.0A ± 5% ± 1% 50mV P-P

> +3.3V and +5V total output not exceed 90W
 > Total output for this subject power supply is 180W