• FSP220-60LE 9PA2201112 Drawing

Connectors:

• 1x 20+4-pin Main Connector
• 1x       4-pin P4 (2x2)
• 2x     15-pin SATA Power
• 3x       4-pin Peripheral / IDE Power
• 1x       4-pin Floppy Power

Features:

• 80Plus Certified
• Supports AMD/Intel CPU System
• 220-Watt Continuous Output
• 40mm Cooling Fan System
• Thermal Control System Linked to Fan
• Energy Saver, 1-Watt Standby Mode
• High Power Conversion Efficiency
• Active PFC, Full Range Input

Specification:

Cooling Fan(s):	Single, 40mm ball-bearing fan linked with Thermal Sensor
Total Output Power:	220-Watt Total Continuous Output @ 30°C
NVIDIA SLI Support	N/A
AMD/ATI Crossfire Support:	N/A
80Plus Certified:	Yes, 80Plus Certified
Modular Cable:	N/A
Safety Approval:	UL, NEMKO, TUV, CSA, IEC, CE
MBTF:	100,000 Hours @ Typical
Unit Size:	80.0mm (W) X 150.0mm (D) X 40.0mm (H)
Unit Weight:	3.0 ls (S)

Input Characteristics:

• Input Range: 115V AC ~ 230V AC
• Frequency: 47 ~ 63Hz
• Power Factor Correction (PFC): Active PFC, Full Range
• Input Current:
  5.0A @ 115 Vrms, 60 Hz
  3.0A @ 230 Vrms, 50 Hz
• Input Protection: Patented Input Fuse Protection

Output Characteristics:
 

Output Voltage	Minimum Load	Normal Load	Maximum Load	Load Reg.	Line Reg.	Ripple Noise
+3.3V	0.5A	---	14A	± 5%	---	50mV
+5V	0.5A	---	16A	± 5%	---	50mV
+12V1	1.0A	---	16A	± 5%	---	120mV
+12V2	1.0A	---	10A	± 5%	---	120mV
-12V	0.0A	---	0.8A	± 10%	---	120mV
+5Vsb	0.0A	---	2.5A	± 5%	---	50mV
> 220W (50°C): +3.3V, +5V, and +12V total output cannot exceed 207W > 250W (25°C): +3.3V, +5V, and +12V total output cannot exceed 237W > The +12V1 and +12V2 total output shall not exceed 17A > +3.3V and +5V total output not exceed 110W > Total output for this subject power supply is 250W > Ripple and noise measurements shall be made under all specified load conditions through a    single pole low pass filter with 20MHz cutoff frequency. Outputs shall bypassed at the    connector with a 0.1uF ceramic disk capacitor and a 10uF electrolytic capacitor to simulate    system loading.