 |
||||||||||||||||||||||||||||||||||||||||||
|
FLEX ATX Switching Power
Supply FSP150-50PL (FSP150-50PL-B Flex ATX) WxHxL: 3.2x1.6x6-inch (81.5x40.5x150mm) PS-FLX-FSP150-50PL Down Load FSP150-50PL (FSP150-50PL-B) Drawing Connectors: > 1x 20-pin Main Connector > 2x 4-pin Peripheral / IDE Power Features: > Complied with Flex ATX standard > High efficiency and reliability > Remote On/Off function > Internal 12V DC fan included > Noise Killer (Thermal fan speed control function) > Low noise and ripple > Complies with FCC part 15 subpart J Class B and CISPR 22 Class B > Output over voltage, short circuit, and over current protection > 100% Hi-pot, ATE, and burn-in tested > Re-settable power shut down > Approved by UL 1950, CSA C22.2 Level 3, TUV EN60950, NEMKO EN60950 (CB Report) Specification: > Temperature Range: Operating 0° C ~ +35° C on full load; storage & shipping -20° C ~ +80° C > Humidity: 95% on operating and 95% on storage > Dielectric Withstand: Input to frame ground 1800V AC for 1 second > Efficiency: 68% at minimum measured at nominal AC main voltage and frequency with maximum load on all output > Rise Time: Less than 20ms > Hold-up Time: 17ms minimum at nominal input voltage > Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible) > Leakage Current: Not exceed 0.75mA at 115V AC, 60Hz > MTBF: 50,000 hours on maximum load at +25° C degree > Dimension (WxHxL): 81.5x40.5x150mm/3.2”x1.6”x6” inches Input Characteristics: > Input Range: 90~132/180~264V AC, Manual Selection > Frequency: 47~63Hz > Input Current: 4A (RMS) @115V AC, 2A (RMS) @230V AC > Inrush Current: 50A Max for 115V AC, 80A Max for 230V AC Cold start Output Characteristics:
|
||||||||||||||||||||||||||||||||||||||||||