FLEX 12V Switching Power Supply
 FSP135-60PF-BL (FSP135-60PF Flex ATX 9PA1350102)
WxHxL: 3.23x1.69x7.48-inch (82x42.9x190mm)
PS-FLX-FSP135-60PFBL

 Down Load FSP135-60PF-BL PDF Drawing

Connectors:
> 1x 20-pin Main Connector
> 3x 4-pin Peripheral / IDE Power
> 1x 4-pin Floppy Power

Features:
> Complied with Flex ATX standard
> High efficiency and reliability
> Remote On/Off function
> Internal 12V DC fan included
> Noise Killer (Thermal fan speed control function)
> Low noise and ripple
> Complies with FCC part 15 subpart J Class B and CISPR 22 Class B
> Output over voltage, short circuit, and over current protection
> 100% Hi-pot, ATE, and burn-in tested
> Re-settable power shut down
> Approved by UL 1950, CSA C22.2 Level 3, TUV EN60950, NEMKO (CB Report)

Specification:
> Temperature Range: Operating 0° C ~ +50° C on full load; storage & shipping -20° C ~ +80° C
> Humidity: 95% on operating and 95% on storage
> Dielectric Withstand: Input to frame ground 1800V AC for 1 second
> Efficiency: 68% at minimum measured at nominal AC main voltage and frequency with maximum load on all output
> Rise Time: Less than 20ms
> Hold-up Time: 20ms minimum at nominal input voltage
> Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
> Leakage Current: Not exceed 0.75mA at 115V AC, 60Hz
> MTBF: 50,000 hours on maximum load at +25° C degree
> Dimension (WxHxL): 82x42.9x190mm/3.23”x1.69”x7.48” inches

Input Characteristics:
> Input Range: 90~132/180~264V AC, Full Range Input
> Frequency: 47~63Hz
> Input Current: 4A (RMS) @115V AC, 2A (RMS) @230V AC
> Inrush Current: 50A Max for 115V AC, 80A Max for 230V AC Cold start

Output Characteristics:
Output Voltage Minimum Load Maximum Load Load Reg. Line Reg. Ripple Noise
+3.3V 0.0A 8.0A ± 5% ± 1% 50mV P-P
+5V 1.5A 12.0A ± 5% ± 1% 50mV P-P
+12V 0.1A 4.0A ± 5% ± 1% 120mV P-P
-5V 0.0A 0.1A ± 10% ± 2% 100mV P-P
-12V 0.0A 0.2A ± 10% ± 2% 120mV P-P
+5Vsb 0.0A 2.0A ± 5% ± 1% 100mV P-P

> +5V and +3.3V total output not exceed 80W