EPS12V ATX12V Switching Power Supply
FSP / SPI FSP650-80GLC SLi Ready
WxHxD: 5.9x3.4x5.5-inch (150x86x140mm)
PS-EPS-650-80GLC

Links:

Connectors:
> 1x 24-pin Main Connector
> 1x   8-pin EPS 12V
> 2x   6-pin PCI Express
> 1x   4-pin P4 12V
> 2x 15-pin SATA Power
> 5x   4-pin Peripheral / IDE Power
> 1x   4-pin Floppy Power


Features:
> Complied with EPS12V and ATX12V standard
> Active Power Factor Correction (PFC) meet EN61000-3-2
> High efficiency and reliability
> Compatible with European Union directive 2002/95/EC (Restriction on Hazardous Substances).
> Remote On/Off function
> Internal 12V DC fan included
> Noise Killer (Thermal fan speed control function)
> Low noise and ripple
> Output over voltage, short circuit, and over current protection
> 100% Hi-pot, ATE, and burn-in tested
> Re-settable power shut down
> Complies with FCC part 15 subpart J class B and CISPR 22 Class B
> Approved by UL 60950, CSA C22.2, TUV or VDE, NEMKO (CB Report), IEC 60950, EN and CE Main Office

Specification:
> Temperature Range: Operating 0C ~ +40C on full load; derate 5W/C from 40C to 50C; Storage & shipping -20C ~ +80C
> Humidity: 5~95% on operating and storage
> Dielectric Withstand: Primary to frame ground 1800V AC for 1 second
> Efficiency: 80% min on 230AC/50Hz & 78% min on 115VAC/60Hz at full load
> Rise Time: Less than 20ms
> Hold-up Time: 17ms minimum at nominal input voltage
> Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible)
> Leakage Current: Less than 3.5mA at 115VAC/60Hz
> MTBF: 100,000 hours on maximum load at +25C
> Dimension (WxHxL): 150x86x140mm/5.9x3.4x5.5

Input Characteristics:
> Input Range: 90~264VAC, Full Range Input
> Frequency: 47~63Hz
> Input Current: 7.5A (RMS) @ 115VAC, 3.6A (RMS) @ 230VAC
> Inrush Current: No damage, typical 100A Max at cold start


Output Characteristics:

Output Voltage Minimum Load Normal Load Maximum Load Load Reg. Line Reg. Ripple Ripple & Noise
+3.3V 0.8A 18A 36A 5% 1% 50mV P-P 100mV P-P
+5V 0.5A 15A 30A 5% 1% 50mV P-P 100mV P-P
+12V1DC 0.0A 7.5A 15A 5% 1% 120mV P-P 200mV P-P
+12V2DC 0.0A 7.5A 15A 5% 1% 120mV P-P 200mV P-P
+12V3DC 0.9A 7.5A 15A 5% 1% 120mV P-P 200mV P-P
+12V4DC 0.1A 7.5A 15A 5% 1% 120mV P-P 200mV P-P
-12V 0.0A 0.25A 0.8A 10% 1% 120mV P-P 200mV P-P
+5Vsb 0.0A 1.0A 2.0A 5% 1% 50mV P-P 100mV P-P

*+3.3V and +5V total output not exceed 155W
*Total output for this subject power supply is 650W