 |
||||||||||||||||||||||||||||||||||||||||||||||||
|
ATX
12V
Power Supply Power-Q ATX-250GU made by FSP / SPI WxHxD: 5.9x3.4x5.5-inch (150x86x140mm) PS-ATX-250GU Down Load ATX-250GU Drawing Connectors: 1x 20-pin Main Connector 1x 4-pin P4 4x 4-pin Peripheral / IDE Power 1x 4-pin Floppy Power Features: • Complied with ATX and ATX12V standard • High efficiency and reliability • Remote On/Off function • Internal 12V DC fan included • Low noise and ripple • Complies with FCC part 15 subpart J class B and CISPR 22 Class B • Output over voltage, short circuit, and over current protection • 100% Hi-pot, ATE, and burn-in tested • Re-settable power shut down • Approved by UL 1950, CSA C22.2 Level 3, CB Specification: • Temperature Range: Operating 0° C ~ +50° C on full load; storage & shipping -20° C ~ +65° C • Humidity: 90% on operating and 95% on storage • Dielectric Withstand: Primary to frame ground 1800VAC for 1 second • Efficiency: 65% at minimum measured at nominal AC main voltage and frequency with maximum load on all output • Rise Time: Less than 20ms • Hold-up Time: 16.6ms minimum at 115V/60Hz; 20ms minimum at 230V/50Hz input voltage • Power Good Signal: Power on delay time 100 ms to 500 ms, off delay 1ms minimum (TTL and CMOS compatible) • Leakage Current: Less than 3.5mA • MTBF: 100,000 hours on maximum load at +25° C degree • Dimension (WxHxL): 150x86x140mm/5.9”x3.4”x5.5” inches Input Characteristics: • Input Range: 95~132/180~264V AC, Manual-select • Frequency: 47~63Hz • Input Current: 6A (RMS) @115V AC, 3A (RMS) @230VAC • Inrush Current: 60A Max for 132V AC Cold Start Output Characteristics:
|
||||||||||||||||||||||||||||||||||||||||||||||||