 |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
ATX
12V
Power Supply Hi-Q Power ATX-300GU(F062) made by FSP / SPI WxHxD: 5.9x3.4x5.5-inch (150x86x140mm) PS-ATX-300GU-F062 Down Load ATX-300GU(F062) Drawing Connectors: 1x 20-pin Main Connector 1x 4-pin P4 1x 6-pin P2 5x 4-pin Peripheral / IDE Power 2x 4-pin Floppy Power Features: • High efficiency • Low noise and ripple • Output over voltage protection • Approved by UL,CSA level 3, CB, FCC, C-TICK • Internal 12V DC fan provided • Short circuit protection on all outputs • 100% burn-in under high ambient temperature (50°C) • 100% Hi-pot tested • Vacuum-impregnated transformer • MTBF: 100K hours at 25°C • line input fuse protection Specification: • Form Factor: ATX 12V • Fan Type: Remote ON/OFF Control (The Power supply shall accept a logic open collector level which will disable /enable all out put voltage ;excluding +5V standby) • Power Factor Correction (PFC): Operating 0°C~50°C, Storage -20°C~+65°C • AC Input: At 115V/ 60 Hz 16.0 ms minimum, At 230V/ 50 Hz 20.0 ms minimum • Dielectric withstand: Input / output 1800VAC for 1 second, Input to frame ground 1800VAC for 1 second • Watts: 300W • Humidity: 5~95% RH • Efficiency: Min 65%, Typical 70% (at full load) • Power good signal: Turn-on delay from 100ms to 500ms • Overload current protection: 150% Max • Over voltage protection: (+5V : 6.5V(maximum)+3.3V :4.6V(maximum)+12V : 15.5V(maximum) • Temperature coefficient: 0.01%/°C • Transient response: output voltage recovers in less than 1 ms max. following a 25% load change Input Characteristics: • Voltage: 115-230VAC switchable • Frequency: 47Hz to 63 Hz • Input Current: 5 Amps Maximum / 230Vrms 50Hz, 10 Amps Maximum / 115Vrms 60Hz Output Characteristics:
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||