|
Power Supply ATX 300W
FSP300-60ATV made by FSP / SPI
WxHxD: 5.9x3.4x5.5-inch (150x86x140mm)
PS-ATX-300-60ATV
Down Load
FSP300-60ATV
Drawing
Connectors:
1x 20-pin Main Connector
1x 4-pin P4
1x 6-pin AUX
6x 4-pin Peripheral / IDE Power
2x 4-pin Floppy Power
Features:
-
Complied with ATX and ATX12V
standard
-
High efficiency and reliability
-
Remote On/Off function
-
Internal 12V DC fan included
-
Noise Killer (Thermal fan speed
control function)
-
Low noise and ripple
-
Complies with FCC part 15 subpart
J class B and CISPR 22 Class B
-
Output over voltage, short
circuit, and over current protection
-
100% Hi-pot, ATE, and burn-in
tested
-
Re-settable power shut down
-
Approved by UL 1950, CSA C22.2
Level 3, TUV EN60950, Nemko (CB Report)
Specification:
-
Temperature Range: Operating 0° C ~ +25° C on full load; storage &
shipping -20° C ~ +65° C
-
Humidity:
90% on operating and 95% on storage
-
Dielectric
Withstand: Primary to frame ground 1800V AC for 1 second
-
Efficiency: 65% at minimum measured at nominal AC
main voltage and frequency with maximum load on all output
-
Rise Time: Less than 20ms on all outputs
-
Hold-up Time: 16.6ms minimum at 115V/60Hz; 20ms
minimum at 230V/50Hz input voltage
-
Power Good Signal: Power on delay time 100 ms to 500
ms, off delay 1ms minimum (TTL and CMOS compatible)
-
Leakage Current: Less than 3.5mA
-
MTBF: 100,000 hours on maximum load at +25° C degree
-
Dimension (WxHxL): 150x86x140mm/5.9"x3.4"x5.5"
inches
Input Characteristics:
-
Input Range: 95~132/190~264V AC, Manual-select
-
Frequency: 47~63Hz
-
Input Current: 10A (RMS) @115V AC, 5A (RMS) @230VAC
-
Inrush Current: 60A Max for 132V AC Cold Start
Output Characteristics:
|
Output Voltage |
Minimum Load |
Maximum Load |
Load Reg. |
Line Reg. |
Ripple Noise |
|
+3.3V |
0.3A |
15/28A |
± 5% |
± 1% |
50mV P-P |
|
+5V |
0.5A |
30/21.5A |
± 5% |
± 1% |
50mV P-P
|
|
+12V |
0.0A |
18.0A |
± 5% |
± 1% |
120mV P-P |
|
-5V |
0.0A |
0.3A |
± 10% |
± 2% |
100mV P-P |
|
-12V |
0.0A |
0.8A |
± 10% |
± 2% |
120mV P-P |
|
+5Vsb |
0.0A |
2.0A |
± 5% |
± 1% |
50mV P-P
|
|
*+3.3V and +5V total output not exceed 200W
*When +3.3V is load to 28A, the +5V maximum load is 21.5A
*When +3.3V is load to 15, the +5V maximum load is 30A
*+3.3V, +5V, and +12V total output not exceed 280W |
|
