ATX
12V
Power Supply
FSP / SPI ATX-300PA
WxHxD: 5.9x3.4x5.5-inch (150x86x140mm)
PS-ATX204-300PA
Links:
Connectors:
> 1x 20+4-pin Main Connector
> 1x 4-pin P4
> 1x 15-pin SATA Power
> 4x 4-pin Peripheral / IDE Power
> 1x 4-pin Floppy Power
Features:
• Complied with ATX12V standard
• High efficiency and reliability, low noise and ripple
• Compatible with European Union Directive 2002/95/EC (Restriction on
Hazardous Substances).
• Remote ON/OFF function
• Internal 12V DC fan included
• Noise Killer (thermal fan speed control function)
• Output over voltage, short circuit, and over current protection
• 100% Hi-pot, ATE, and burn-in tested
• Re-settable power shut down
• Complies with FCC part 15 subpart J class B 115Vac operation, and
CISPR 22 class B at 230Vac operation
• Approved by UL60950, CSA C22.2 NO. 60950, TUV EN60950 or VDE EN60950,
NEMKO EN60950 (CB Report)
Specification:
• Temperature Range: Operating: 0°C ~ +50°C, Full load at 25°C, De-rate
2W/°C from 25°C to 50°C.
• Storage & shipping: -20°C ~ +65°C
• Humidity: 5 ~ 95% on operating and storage
• Dielectric Withstand: Primary frame ground 1800V AC for 1 second
• Efficiency: 70% minimum measured at normal AC mains voltage and
frequency with full load
• Rise time: Less than 20ms
• Hold-up Time: 17ms minimum at nominal input voltage
• Power Good Signal: Power on delay time 100 ~ 500ms, off delay 1ms
minimum (TTL and CMOS compatible)
• Leakage Current: Less than 3.5mA
• MTBF: 100,000 hours on maximum load at +25°C
• Dimensions (LxWxH): 140x150x86mm/5.5x5.9x3.4inch
Input Characteristics:
• Input Range: ±10% of 115Vrms/57~63Hz or 230Vrms/47~53Hz, Manual
Selection
• Input Current: 7A (RMS) @115Vac, 4A (RMS) @230Vac
• Inrush Current: No Damage
Output Characteristics:
|
Output Voltage |
Minimum Load |
Normal Load |
Maximum Load |
Load Reg. |
Line Reg. |
Ripple Noise |
|
+3.3V |
0.5A |
13.5A |
20.0A |
± 5% |
± 1% |
50mV P-P |
|
+5V |
0.3A |
9.0A |
20.0A |
± 5% |
± 1% |
50mV P-P |
|
+12V1 |
1.0A |
6.0A |
16.0A |
± 5% |
± 1% |
100mV P-P |
|
+12V2 |
1.0A |
10.5A |
16.0A |
± 5% |
± 1% |
100mV P-P |
|
-12V |
0.0A |
0.3A |
0.3A |
± 10% |
± 2% |
100mV P-P |
|
+5Vsb |
0.0A |
1.0A |
2.5A |
± 5% |
± 1% |
50mV P-P |
|
*+3.3V and +5V total output not exceed 120W
*+12V1 and +12V2 total output not exceed 264W, +3.3V & +5V & 12V1&
12V2 total output not exceed 280W
*+12V2 Peak loading, Min Voltage during peak is >11.0Vdc
* Total output for this subject power supply is 300W |
|
